HP DesignJet ColorPro - Network Guide

Configuring the JetDirect Print Server Using the Printer’s Front Panel
HP DesignJet ColorPro Series Network Guide 11
• The printer’s graphics language must be set to Auto (the default).
• The EtherTalk network protocol must be enabled (see above).
To see how to access this parameter in the MIO SETUP menu, refer to page 10.
To Configure Novell NetWare Frame Types
In order to be able to configure this parameter, the Novell network protocol must
be enabled (see page 10). To see how to access these parameters in the MIO
SETUP menu, refer to page 10.
To Configure TCP/IP Parameters
The following TCP/IP parameters
• IP address
• Subnet mask
• Syslog server IP address
• Default gateway
• TCP connection timeout
can either be retrieved over the network from a BOOTP download file or entered
manually using the printer’s front panel. By default, they are retrieved from the
network (BOOTP = YES). To be able to enter them manually, set BOOTP to
NO.
Parameter
in the Front
Panel
Options Comments
FRAME AUTO
(default)
All listed NetWare frame types will be
allowed.
EN_SNAP Limits frame types to IPX over SNAP with
IEEE 802.3 frames. All others are counted
and discarded.
EN_8022 Limits frame types to IPX over IEEE 802.2
with IEEE 802.3 frames. All others are
counted and discarded.
EN_11 Limits frame types to IPX over Ethernet
frames. All others are counted and discarded.
EN_8023 Limits frame types to IPX over IEEE 802.3
frames. All others are counted and discarded.