HP DesignJet ColorPro - Network Guide

Sharing the Printer through an HP JetDirect Print Server
HP DesignJet ColorPro Series Network Guide 12
In order to be able to configure any of these parameters, the TCP/IP network
protocol must be enabled (see page 10). To see how to access these parameters
in the MIO SETUP menu, refer to page 10.
Sharing the Printer through an HP JetDirect Print Server
This section describes how to setup network printing using the HP JetDirect print
server and software.
Parameter
in the Front
Panel
Options Comments
BOOTP YES
(default)
The printer retrieves its TCP/IP parameters over
the network from a BOOTP download file that
you set up on your UNIX system. For
configuration instructions, see the HP JetDirect
Print Server Software Installation Guide.
NO The printer is configured to accept TCP/IP
parameters from the front panel, as listed below.
IP BYTE 1
IP BYTE 2
IP BYTE 3
IP BYTE 4
0
(default)
through
255
IP address (four bytes)
SM BYTE 1
SM BYTE 2
SM BYTE 3
SM BYTE 4
0
(default)
through
255
Subnet mask (four bytes)
LG BYTE 1
LG BYTE 2
LG BYTE 3
LG BYTE 4
0
(default)
through
255
Syslog server IP address (four bytes)
GW BYTE 1
GW BYTE 2
GW BYTE 3
GW BYTE 4
0
(default)
through
255
Default gateway (four bytes)
TIMEOUT 0—3600
(default
90)
Timeout for TCP/IP connections, in seconds. If
set to 0, the connection remains open until
closed by the server.