HP MFP Analog - (multiple language -Americas) Fax Guide

ENWW Setting dial-tone detection 23
English
Setting dial-tone detection
Dial-tone detection controls whether or not the fax accessory must
detect a dial-tone before sending a fax. By default, dial-tone detection is
on.
To set dial-tone detection
1 On the control panel, press the menu button to access the main
menu.
2 Select CONFIGURE DEVICE.
3 Select the FAX menu.
4 Select FAX SEND.
5 Select DETECT DIAL TONE.
6 Select ON or OFF.
Setting a dialing prefix
You can set up a dialing prefix to use for all outgoing faxes. You might
need to use a prefix for sending faxes from a PBX system or for a phone
billing number.
To set a dialing prefix
1 On the control panel, press the menu button to access the main
menu.
2 Select CONFIGURE DEVICE.
3 Select the FAX menu.
4 Select FAX SEND.
5 Select DIAL PREFIX.
6 Set DIAL PREFIX to YES.
7 Select PREFIX.
8 Type the dialing prefix to use for outgoing faxes.
Note Depending on the mfp, either the comma (,) button or the pause button is
used to insert a pause. (“Control panel methods” on page 12 provides a
figure of each type of interface.)