HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part I

EN Raster Y Offset Command 15-15

Once in Raster Graphics Mode, PCL commands and text imply an

End Raster Graphics (

*rC) except for the following commands:

z Transfer Raster Data

z Set Raster Compression Method

z Raster Y Offset

In addition, the following commands are ignored (i.e., locked out)

while in Raster Graphics Mode and do not imply an End Raster

Graphics command:

z Start Raster Graphics

z Set Raster Width

z Set Raster Height

z Set Raster Presentation Mode

z Set Raster Graphics Resolution

Notes An implied End Raster Graphics resets the Raster Compression

Method 3 seed row, but does not reset the Raster Compression

Method nor the left raster graphics margin.

If source and/or transparency modes have been set, frequent

start/end graphics commands in an image can result in a memory

overflow condition.

Raster Y Offset Command

The Raster Y Offset command moves the cursor position vertically

the specified number of raster lines from the current raster position in

the raster area.

* b # Y

# =Number of raster lines of vertical movement

Default = N/A

Range = 0 - 32767

This command is recognized only while in raster graphics mode and

only within the raster area.