HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

EN RP, Replot 19-39

RP, Replot

This command is ignored by the printer; to eject a page, the printer

must be in PCL printer language mode. The following commands

cause a conditional page eject; a page is ejected if there is any

printable data in the print buffer:

E Reset

z UEL (Universal Exit Language)

z Flush All Pages

z Page Length

z Page Size

z Orientation

z Paper Source

The PCL Form Feed control code causes an unconditional page eject

and advances the cursor position to the top of form on the next page.

Note A page eject caused by any of the above commands except Paper

Source defaults the HP-GL/2 pen position.

To print more than one plot, use the Number of Copies command.

For information about printing more than one copy of an HP-GL/2

illustration, see “Number of Copies Command” in Chapter 4.