HP PCL/PJL reference - Printer Job Language Technical Reference Manual

EN Environment Commands 6-23
REFILLTHRESHOLD Specifies as a percentage the level of
ink remaining in the pen before a refill is
started. 100% means that refilling takes
place when there is no usable ink
remaining in the pen. Lower threshold
values cause the printer to analyze the
density of colors of the next swaths. If
the density is increasing, the refill is
done as soon as the threshold value is
reached. If the density is decreasing,
the refill is delayed until the density
starts increasing again or the minimum
ink level is reached. Mid-print refill
banding is less noticeable in lighter
areas of a print. A threshold of 80%
means that the printer may start refilling
when the ink level has dropped by 80%
of the charge level. If the charge level
was 15.5 cc, the threshold is reached
when 12.4 cc of usable ink remains in
the pen.
5 to 100
REFILLTYPE Specifies when a pen refill is to take
place. A SHARP refill is done only
between swaths; all passes of the
printhead for the current swath are
completed before refilling takes place.
An INTERLEAVED refill can be done
between two passes of the same swath.
INTERLEAVED,
SHARP
RENDERMODE Sets the render mode for the
personality.
COLOR,
GRAYSCALE
REPRINT Determines whether pages are
reprinted after a paper jam. When
AUTO is selected and the amount of
RAM installed is below a printer-specific
threshold, pages are not reprinted. If
the amount of RAM installed is more
than this threshold, they are reprinted.
The ON setting causes the printer to
reprint the job after a paper jam. OFF
disables reprinting.
AUTO, OFF, ON
General PJL Environment Variables (continued)
Variable Description
Sample Value
Range