start printed on recycled paper copyright ©2002 Hewlett-Packard Company printed in Singapore hp color LaserJet 2500 series www.hp.
Copyright and License ©Copyright Hewlett-Packard Company 2002 All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. Part number: C9706-90952 First Edition: July 2002 FCC Regulations This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
HP Color LaserJet 2500L HP Color LaserJet 2500n Printer configurations. All HP Color LaserJet 2500 series printers come with the same features as the 2500L model: a 125-sheet multipurpose tray (tray 1), parallel and universal serial bus (USB) interface ports, a slot for an optional HP print server card, and 64 MB RAM. The 2500 model also includes a 250-sheet tray (tray 2). The 2500n model includes tray 2 and an HP Jetdirect 615n print server card.
504 mm (19.84 in) 366 mm (14.41 in) 3 318 mm (12.53 in) 2 Bahasa Indonesia English 742.9 mm (29.25 in) Prepare the location. Place the printer on a sturdy, level surface in a well-ventilated area. Make sure there is enough space around the printer so that the air vents on the left side and rear of the printer are not blocked. Regulate the environment. Do not place the printer in direct sunlight or an area that has abrupt temperature and humidity changes.
4 2 1 3 4 5 6 Minimum system requirements. See the outside of the box in which the printer shipped, or see the Readme on the CD-ROM. Check the package contents. 1) the printer; 2) a power cable; 3) a CD-ROM (includes the user guide and printer software); 4) this getting started guide 5) an imaging drum; and 6) four print cartridges: yellow (Y), magenta (M), cyan (C), and black (K). Note: Parallel and USB cables are not included. Persyaratan sistem minimal.
2 7 3 1 4 1 5 2 6 3 7 4 8 10 5 9 6 11 Bahasa Indonesia English 7 Locate the printer parts. 1) power switch; 2) top output bin; 3) control panel; 4) top cover; 5) tray 1; 6) tray 2 (2500, 2500n, and 2500tn models); 7) tray 3 (2500tn model); 8) dual inline memory module (DIMM) access door; 9) interface ports, 10) rear output door; and 11) power connector. Understand the control panel.
9 8 Remove the packing materials. Remove all orange tape from the printer. Remove the shipping locks. Open tray 2 and tray 3 and remove the orange shipping lock inside each tray. Membuka kemasan. Lepaskan pita oranye dari printer. Lepaskan kunci pengapalan. Buka nampan 2 dan nampan 3 lalu lepaskan kunci pengapalan berwarna oranye di dalam tiap nampan.
11 Bahasa Indonesia English 10 Install tray 3. Place tray 3 in the location you want. Lift the printer, align it with the pegs on tray 3, and lower the printer onto the tray. Note: Only one 500-sheet tray (tray 3) can be installed. Adjust the guides on tray 3. Letter-size paper: 1) Pull the tray out of the printer. 2) Raise the blue rear stop and move the blue width guides outward until they click. A4-size paper: Lower the blue rear stop. The blue width guides should already be set for A4-size paper.
13 12 2 3 Load paper in tray 3. 1) Load the paper with the side to be printed face down, top edge toward the front. 2) Make sure the paper is flat at all corners and below the height marks. Note: Never fan paper before loading. 3) Slide the tray back into the printer. Adjust the guides on tray 2. 1) Pull the tray out of the printer. 2) Move the blue width guides to match the paper size being loaded. 3) Extend the rear of the tray until the arrow points to the paper size being loaded.
Bahasa Indonesia English 14 15 Load paper in tray 2. 1) Load the paper with the side to be printed face down, top edge toward the front. 2) Make sure the paper is flat at all corners and below the height marks. Note: Never fan paper before loading. 3) Push down on the paper to lock the metal plate in the tray into place. 4) Slide the tray back into the printer. Load tray 1. 1) Open tray 1 and slide out the tray extender. 2) Slide the width guides until they are slightly wider than the paper.
17 16 1 2 3 4 2 Connect the power cable and turn on the printer. 1) Connect the power cable between the power connector on the back of the printer and an ac outlet. 2) Press the power switch on the left side of the printer. Install the imaging drum. 1) Remove the imaging drum from its packaging. 2) Place the imaging drum on a firm surface and pull the orange rings to remove the shipping pins. 3) Remove the orange shipping lock on each end of the imaging drum. 4) Remove the two orange shipping spacers.
5 Bahasa Indonesia English 6 5) Remove the orange cover from the imaging drum. CAUTION: Do not touch the surface of the white roller or print-quality issues can occur. 6) Open the top cover of the printer. 7) Align the white roller on the imaging drum with the green arrows inside the printer. 5) Lepaskan penutup oranye dari drum tinta. PERHATIAN: Jangan menyentuh permukaan putih penggulung atau akan terjadi masalah kualitas cetakan. 6) Tarik nampan keluar dari printer.
18 8) Lower the imaging drum into the printer and press it firmly into place. Install the print cartridges. 1) Look inside the printer on the right to see which print-cartridge slot is in the access position. 2) Locate the color of print cartridge that matches the color of the slot and remove the print cartridge from its packaging. 8) Turunkan drum tinta ke dalam printer lalu tekan ke tempatnya. Pasang cartridge.
English Bahasa Indonesia 3) Remove the orange cover from the print cartridge. 4) Place the print cartridge on a flat surface and pull the orange tab straight out to remove the sealing tape. CAUTION: Do not touch the surface of the roller or print-quality issues can occur. 5) Squeeze the blue release levers on the print cartridge, holding it with the roller facing you. Lower the cartridge straight down into the carousel until it is firmly in place. 3) Lepaskan penutup oranye dari cartridge.
19 6) Close the top cover. When the green Go light begins blinking, press ROTATE CAROUSEL. Repeat this process (step 18) to install the other three print cartridges. Bring the printer to the Ready state. Close the top cover. After 60 seconds, the green Ready light turns on. 6) Tutuplah. Apabila lampu hijau Go (Jalankan) berkedip, tekan ROTATE CAROUSEL. Ulangi proses ini (langkah 18) untuk menginstalasi tiga cartridge lainnya. Atur printer ke posisi Ready (Siaga).Tutuplah.
Bahasa Indonesia English 20 21 Print a Demo page. With the Ready light on, press GO to print a Demo page, which verifies that the printer works. Note: If the page does not print, reconnect the power cable. Make sure the Ready light is on and no other lights are on or blinking. Make sure paper is loaded and supplies are installed correctly. Choose ONE of these installations. To connect directly for Windows®, go to step 22. To install for a network, go to step 23.
22 To connect directly for Windows. 1) Place the CD-ROM in the CD-ROM drive. 2) When prompted, click Install Printer and follow the instructions. (If the welcome screen does not open, click Start and then Run. Type X:SETUP, replacing “X” with the CD-ROM drive letter, and click OK.) 3) Click Finish. 4) Before you restart the computer, connect the cable between the printer and the computer. You cannot connect parallel and USB cables at the same time. Note: Parallel and USB cables are not included.
Bahasa Indonesia English 23 Install for a network. (Note: The 2500n and 2500tn have an HP JetDirect print server card for network connection.) For a 10/100 Base-T network, connect a twisted-pair network cable between the printer port and an active network port. Print an HP Jetdirect page. Make sure the Ready light is on. Press GO and CANCEL JOB simultaneously to print a Configuration page, an HP Jetdirect page, and a Supplies Status page. On the HP Jetdirect page, locate the printer’s IP address.
Install the network software. 1) Place the CD-ROM in the CD-ROM drive and follow the instructions. 2) Click Finish and restart the computer. 3) To set up a Macintosh computer to use the network printer, see the next frame. Otherwise, go to step 27. Macintosh on the network. 1) Run the Installer and restart the computer. OS 8.6 to 9.2x: From HD/Applications/Utilities, use the Apple Desktop Printer Utility to select this printer.
Bahasa Indonesia English 24 Plug and Play. If you connected a parallel or USB cable to a Windows computer before you installed software, the “New Hardware Found” message appears when you turn on the computer. 1) Windows 98 and Millennium Edition (Me): Click Search CD-ROM drive, click Next, and follow the instructions. 2) Go to step 27. Windows 2000 and XP: 1) Click Search. 2) On the Locate Driver Files screen, select the Specify a Location check box, clear all other check boxes, and click Next.
25 Install the printer driver only (Windows 95). If the printer is connected to the network, have the network administrator add a port. 1) Click Start, point to Settings, and click Printers. Double-click Add Printer and follow the instructions. When prompted for a manufacturer, click Have Disk. (Go to the next frame.) 2) Double-click the folder for your language and double-click Drivers. 3) Double-click Win95, and then double-click the folder for the driver you want (PCL 6, PCL 5e, or PS).
26 Bahasa Indonesia English Mac OS 8.6 - 9.x Connect the printer directly to a Macintosh. Connect a USB cable between the USB port on the printer and the USB port on the computer. You cannot connect parallel and USB cables at the same time. Note: A USB cable is not included. Use a 2-meter standard USB cable. OS 8.6 to 9.2x: 1) Run the Installer and restart. Run the Apple Desktop Printer Utility from HD/Applications/Utilities. 2) Double-click Printer (USB). Next to USB Printer Selection, click Change.
27 Mac OS X OS X: From HD/Applications/Utilities/Print Center, start the Print Center. The printer sets up automatically. Test the software installation. Print a page from any program to make sure the software is correctly installed. Note: If installation fails, reinstall the software. If reinstallation fails, see the Readme, see the flyer that came in the printer box, or go to http://www.hp.com/support/clj2500 for help or more information.
Bahasa Indonesia English 28 Congratulations! Your printer is ready to use. See the HP Color LaserJet 2500 Toolbox (Windows 98 and later), where you can open the user guide and use tools to solve problems. Note: You must have performed a complete software installation to use the Toolbox. Selamat! Printer Anda siap digunakan. Lihat HP Color LaserJet 2500 Toolbox (Windows 98 dan diatasnya), di mana Anda dapat membuka buku panduan dan menggunakan perangkat-perangkat untuk memecahkan masalah.
24
25
26
start copyright © 2002 Hewlett-Packard Company hp color LaserJet 2500 series www.hp.
