HP Color LaserJet CP3505 Series Printers - User Guide

7. Press to select CONFIG METHOD.
8. Press
to highlight MANUAL, and then press .
9. Press
to highlight MANUAL SETTINGS, and then press .
10. Press
to highlight DEFAULT GATEWAY, and then press .
11. Press the
or arrow to increase or decrease the number for the first byte of the default
gateway.
12. Press
to move to the next set of numbers. (Press to move to the previous set of numbers.)
13. Repeat steps 10 and 11 until the correct default gateway is entered, and then press
to save the
default gateway.
14. Press Menu to return to the Ready state.
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
●
Decreases printer-generated network traffic
●
Prevents unauthorized users from printing to the printer
●
Provides only pertinent information on the configuration page
●
Allows the printer control panel to display protocol-specific error and warning messages
Disable IPX/SPX
NOTE: Do not disable this protocol in Windows-based systems that print to the printer using IPX/SPX.
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight IPX/SPX, and then press .
6. Press
to select ENABLE.
7. Press
to highlight OFF, and then press .
8. Press Menu to return to the Ready state.
Disable AppleTalk
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
ENWW Network configuration 57