HP Color LaserJet CP3505 Printer - Software Technical Reference

Wait Timeout
This control specifies how long the product waits to get more postscript information from the computer.
After the specified time passes, the product stops trying to print the document and prints an error
message. If you are trying to print a very complicated document, you might want to increase this value.
If you specify 0 seconds, the product waits indefinitely. The default setting is 300 seconds. You can
use the spin box to change this value to a maximum of 32,767 seconds.
Minimum Font Size to Download as Outline
This control specifies the minimum font size (in pixels) for which the driver downloads TrueType fonts
as outline (Type 1) fonts. A font smaller than the minimum setting is downloaded as a bitmap (Type 3)
font. Use this option to fine-tune the Automatic setting for the TrueType Font Download option on
the Advanced tab in Document Defaults. The default setting is 100 pixels. You can use the spin box
to change this value to a maximum of 32,767 pixels.
Maximum Font Size to Download as Outline
This control specifies the maximum font size (in pixels) for which the driver will download TrueType fonts
as bitmap (Type 3) fonts. A font larger than the maximum setting will be downloaded as an outline (Type
1) font. Use this option to fine-tune the Automatic setting or override the Send TrueType as Bitmap
setting for the TrueType Font Download option on the Advanced tab in Document Defaults. The
default setting is 600 pixels. You can use the spin box to change this value to a maximum of 32,767
pixels.
Installable Options
This section provides information to configure the printing options that you can install for the HP Color
LaserJet CP3505 printer. The following controls are available:
●
Automatic Configuration
●
Tray 3
●
Duplex Unit (for 2-Sided Printing)
●
Allow Manual Duplexing
●
Printer Memory
●
Printer Hard Disk
●
Job storage
●
Mopier Mode
●
Postscript Passthrough (PS Emulation Print Driver only)
●
JPEG Passthrough (PS Emulation Print Driver only)
Automatic Configuration
Use the Device Settings tab to tell the driver about the hardware configuration of the product. If
bidirectional communication is enabled in a supported environment, set up this tab by selecting the
Update Now setting in the Automatic Configuration setting. The default setting is Off. After an
automatic configuration, the setting returns to Off after the changes are made.
ENWW Device Settings tab features 169
HP print drivers for
Windows