HP LaserJet P2010 Series - Software Technical Reference

The Front Cover and Back Cover options are as follows:
●
Add a Blank or Preprinted Cover check box
●
Source is: drop-down menu
●
Type is: drop-down menu
When you select Front Cover or Back Cover, also select the Add a Blank or Preprinted Cover check
box to enable the setting. When this check box is selected, the Source is: and Type is: drop-down
menus become available and a check mark appears next to the Front Cover or Back Cover option.
NOTE: The Back Cover options are not available when the Booklet Layout setting is enabled on
the Finishing tab. For two-page-per-sheet (2-up) booklet printing, include a cover by selecting different
media for the first page only. The back cover setting is unavailable, because this page would be printed
in the middle of a booklet.
The Source is: setting specifies the source tray to use for adding a back cover to the document. The
list of source trays depends on the installed accessories. Any optional media trays that are installed
through the Configure tab also appear here. For more information about the Source is: setting,
see
Source is: on page 82.
The Type is: drop-down menu shows all of the media types that the printer supports. For more
information about the Type is: settings, see
Type is: on page 82.
First Page, Other Pages, and Last Page options
Use these options to select an alternative media size, type, or source for the first page, other pages, or
last page of a document. The following illustration shows the appearance of the Paper Options group
box when the Use Different Paper/Covers check box is selected.
Figure 4-8 First Page, Other Pages, and Last Page options
ENWW Driver tabs 85
Host-based driver for
Windows