HP LaserJet P2010 Series - Software Technical Reference

Win98se APW Install
1. Ensure the HP LaserJet P2010 Series printer has not been plugged in and is not connected to the
computer.
2. From the Start menu, point to Settings, and click Printers.
3. Double-click Add Printer, then click Next.
4. Follow the directions on screen.
5. When asked if the product is a local or network printer, select Local Printer.
6. Select "Have Disk" and then specify the location of the HP LaserJet P2010 Series driver to be
installed.
7. If multiple selections are presented, select your printer model and click Next.
8. If you are installing via USB and have not previously installed the HP LaserJet P2010 Series printer,
there will not be a USB port installed yet. This is normal. Select LPT1: and click Next.
9. If you are installing via USB and have previously installed and connected the HP LaserJet P2010
Series, there will be a USB port installed. Select this USB port and click Next .
NOTE: Ensure that you connect the HP LaserJet P2010 Series to the same physical USB port
you previously had it connected to.
10. Files are copied, and a "Welcome" screen should be displayed.
11. Follow the directions on screen.
12. When asked to connect the printer, plug in and connect the HP LaserJet P2010 Series printer to
your computer.
13. Follow the directions on the screen until installation is completed.
When installation is completed you may have two copies of the print driver created. If this is the case,
you should delete the first one created. Typically it will have the same name as your printer model. To
check how many drivers were created, and to delete the first one, follow the steps below.
1. From the Start menu, point to Settings, and click Printers.
2. If you have both " HP LaserJet P2010 Series " and "HP LaserJet P2010 Series (Copy 2)", do not
delete the one with "Copy 2" in the name. Instead delete the first driver created called "HP LaserJet
P2010 Series ".
At this point you are ready to print using the "HP LaserJet P2010 Series (Copy 2)" driver.
Installing IPV6 printer
IPv6 installation will require IPv4 to be installed first.
1. Using the CD, install the printer as an IPv4 printer.
2. From the Start menu, open the Printers and Faxes folder. Right click on the printer and select
Properties. Select the Ports tab and click on Configure Port.
142 Chapter 6 Engineering details ENWW