HP Color LaserJet CP2020 Series - Software Technical Reference

●
Wait Timeout
●
Minimum Font Size to Download as Outline
●
Maximum Font Size to Download as Bitmap
●
Postscript Passthrough
●
JPEG Passthrough
Available PostScript Memory
This control specifies the amount of available postscript memory and provides a spin box for changing
this value. The available postscript memory is a subset of the product's total physical memory. It is
usually best to set the postscript memory to match the total RAM that appears on the configuration page.
To print a configuration page from the product control panel, follow these steps:
1. Press OK to open the menus.
2. Press the Left arrow or Right arrow button to navigate to Main menu/Reports. Press OK.
3. Press the Left arrow or Right arrow button to navigate to Reports/Config report. Press OK to
print the configuration report.
Output Protocol
This control specifies the protocol that the product uses for print jobs. The following options are
available:
●
ASCII (default)
●
TBCP
●
Binary
Click ASCII to send data in ASCII format (7-bit), which might take longer to print but can be sent through
any I/O channel, such as a serial or network port.
Click TBCP (Tagged Binary Communications Protocol) to send all data except special control characters
in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster
than sending data in ASCII format.
Click Binary to send all data except special control characters in binary (8-bit) format. The binary formats
can be sent over serial communications ports and are faster than sending data in ASCII format.
Send Ctrl-D Before Each Job
This control specifies whether the product is reset at the beginning of every postscript document. The
default setting is No. Pressing Ctrl-D resets the product to its default setting to ensure that previous print
jobs do not affect the current print job. Using Ctrl-D might cause a print job to fail if the product is
connected through a network. If the document fails to print when sent to a product connected through
serial ports, change No to Yes.
Send Ctrl-D After Each Job
This control specifies whether the product is reset at the end of every postscript document. The default
setting is Yes. Pressing Ctrl-D resets the product to its default setting to ensure that future print jobs are
224 Chapter 4 HP PCL 6 print driver and HP PS Universal Print Driver for Windows ENWW
HP PCL 6 print driver and
HP PS Universal Print
Driver for Windows