User's Manual

Nero Cover Designer Settings • 38
3. Click on the 'Print Calibration Sheet' button.
4. Take the paper out of the printer. Fold the paper horizontally and vertically in the
middle.
The dotted line indicates the current calibration setting.
5. Unfold the paper again and compare where the horizontal and vertical fold lines
meet the intersection of the axes.
The intersection point indicates printer deviation in millimeters relative to the
center of the page.
6. If there is a difference between the fold lines and the current setting, enter the
actual horizontal and vertical values on the 'Printing' tab and then print another
calibration sheet.
7. Fold that paper again horizontally and vertically in the middle. The fold lines
should now coincide with the dotted lines. If this is the case, you have
successfully competed printer calibration. (If not, repeat the appropriate steps to
perform the calibration.)
8. Click on the 'OK' button to close the tab and end calibration.
In the field 'Bleeding' you can set how much of the area surrounding the cove
r
elements should be printed.