HP LaserJet Enterprise 500 Color MFP M575-Warranty and Legal Guide

电信（传真）产品的其它声明

欧盟电信运营声明

本产品设计用于连接到欧洲经济区 (EEA) 国家/地区的模拟公共交换电话网 (PSTN)。

它符合 EU R&TTE Directive 1999/5/EC (Annex II) 的要求，并带有 CE 合格标志。

有关详细信息，请参阅本手册其它部分中制造商发布的一致性声明。

然而，由于各个国家/地区的 PSTN 间存在着差异，本产品不能无条件保证在每个 PSTN 终接点上都

可以成功运行。产品的网络兼容性取决于客户准备 PSTN 连接时所选的适当设置。请按照用户手册中

提供的说明进行操作。

如果您遇到网络兼容性问题，请联系您的设备供应商或产品运行所在国家/地区的 Hewlett-Packard 帮

助台。

与 PSTN 端点的连接可能需要满足当地 PSTN 运营商的其它要求。

New Zealand Telecom Statements

The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has

accepted that the item complies with minimum conditions for connection to its network. It

indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.

Above all, it provides no assurance that any ite

m will work correctly in all respects with

another item of Telepermitted equipment of a different make or model, nor does it imply that

any product is compatible with all of Telecom’s network services.

This equipment may not provide for the effective hand-over of a call to another device

connected to the sa

me line.

This equipment shall not be set up to make automatic calls to the Telecom “111”

Emergency Service.

This product has not been tested to ensure compatibility with the FaxAbility distinctive ring

service for New Zealand.

Additional FCC statement for telecom products (US)

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the

ACTA. On the back of this equipment is a label that contains, among other information, a

product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be

provided to the telephone company.

The REN is used to det

ermine the quantity of devices, which may be connected to the

telephone line. Excessive RENs on the telephone line may result in the devices not ringing in

response to an incoming call. In most, but not all, areas, the sum of the RENs should not

exceed five (5.0). To be certain of the nu

mber of devices that may be connected to the line,

as determined by the total RENs, contact the telephone company to determine the maximum

REN for the calling area.

This equipment uses the following USOC jacks: RJ11C.

An FCC-compliant telephone cord and modular plug is provided with this equipment. This

equipment is de

signed to be connected to the telephone network or premises wiring using a

compatible modular jack, which is Part 68 compliant. This equipment cannot be used on

ZHCN

电信（传真）产品的其它声明