HP LaserJet M1130/M1210 MFP User Guide

1. On the control panel, press the Setup button.
2. Use the arrow buttons to select the Fax setup menu, and then press the OK button.
3. Use the arrow buttons to select the Fax Recv. setup menu, and then press the OK button.
4. Use the arrow buttons to select the Forward fax menu, and then press the OK button.
5. Use the arrow buttons to select the On or Off option, and then press the OK button.
6. If you turn on the fax-forwarding feature, use the keypad to specify the fax number where the fax is to
be sent, and then press the OK button to save the selection.
Set the answer mode
Depending on the situation, set the product answer mode to Automatic, TAM, Fax/Tel, or Manual. The
factory-set default is Automatic.
●
Automatic: The product answers incoming calls after a specified number of rings or upon recognition of
special fax tones.
●
TAM: The product does not automatically answer the call. Instead, it waits until it detects the fax tone.
●
Fax/Tel: The product answers incoming calls immediately. If it detects the fax tone, it processes the call
as a fax. If it does not detect the fax tone, it creates an audible ring to alert you to answer the incoming
voice call.
●
Manual: The product never answers calls. You must start the fax-receiving process yourself, either by
pressing the Send Fax
button on the control panel or by picking up a telephone that is connected to
that line and dialing 1-2-3.
To set or change the answer mode, complete the following steps:
1. On the control panel, press the Setup
button.
2. Use the arrow buttons to select the Fax setup menu, and then press the OK button.
3. Use the arrow buttons to select the Fax Recv. setup menu, and then press the OK button.
4. Press the OK button to select the Answer mode menu.
5. Use the arrow buttons to select the answer mode, and then press the OK button.
Block or unblock fax numbers
If you do not want to receive faxes from specific people or businesses, you can block as many as 30 fax
numbers by using the control panel. When you block a fax number and someone from that number sends you
a fax, the control-panel display indicates that the number is blocked, the fax does not print, and the fax is not
saved in memory. Faxes from blocked fax numbers appear in the fax activity log with a “discarded”
designation. You can unblock blocked fax numbers individually or all at one time.
NOTE: The sender of a blocked fax is not notified that the fax failed.
Complete the following steps to block or unblock fax numbers by using the control panel:
1. On the control panel, press the Setup
button.
2. Use the arrow buttons to select the Fax setup menu, and then press the OK button.
ENWW Set fax settings 115