HP LaserJet M1130/M1210 MFP User Guide

4. Use the arrow buttons to select the Fit to page menu, and then press the OK button.
5. Use the arrow buttons to select the On or Off option, and then press the OK button to save the
selection.
Set fax reprint settings
The default fax reprint setting is On. To change this setting from the control panel, complete the following
steps:
1. On the control panel, press the Setup
button.
2. Use the arrow buttons to select the Fax setup menu, and then press the OK button.
3. Use the arrow buttons to select the Fax Recv. setup menu, and then press the OK button.
4. Use the arrow buttons to select the Reprint faxes menu, and then press the OK button.
5. Use the arrow buttons to select the On or Off option, and then press the OK button.
Set the silence-detect mode
This setting controls whether or not you can receive faxes from older-model fax machines that do not emit a
fax signal during fax transmissions. At the time of this publication, these silent-model fax machines
represented very few of the fax machines in use. The default setting is Off. The silence-detect mode setting
should be changed only if you regularly receive faxes from someone who uses an older-model fax machine.
1. On the control panel, press the Setup
button.
2. Use the arrow buttons to select the Fax setup menu, and then press the OK button.
3. Use the arrow buttons to select the Fax Recv. setup menu, and then press the OK button.
4. Use the arrow buttons to select the Silence detect menu, and then press the OK button.
5. Use the arrow buttons to select the On or Off option, and then press the OK button to save the
selection.
Set the fax volume
Control the volume of the fax sounds from the control panel. You can make changes to the following sounds:
●
The fax sounds that are associated with incoming and outgoing faxes
●
The ring for incoming faxes
The factory-set default for the fax-sounds volume is Soft.
Set the alert volume, phone-line volume, and ring volume
1. Press the Setup
button.
2. Use the arrow buttons to select the System setup menu, and then press the OK button.
3. Use the arrow buttons to select the Volume settings menu, and then press the OK button.
4. Use the arrow buttons to select the Alarm volume menu, the Phoneline volume menu, or the Ring
volume menu, and then press the OK button.
118 Chapter 10 Fax (M1210 Series only) ENWW