HP LaserJet M1130/M1210 MFP User Guide

a. At the Home screen on the product control panel, press the button.
b. Use the arrow buttons to scroll to the HP Web Services menu, and then press the OK button.
c. Use the arrow buttons to scroll to the Enable Web Services option, and then press the OK button.
An information page prints.
2. For advanced configuration options, enable HP Web Services in the HP Embedded Web Server (EWS) by
following these steps:
a. After the product is connected to the network, print a configuration page and identify the product
IP address.
b. At your computer, open a Web browser and enter the product IP address into the address line. The
HP EWS appears.
c. Click the HP Web Services tab. If your network does not use a proxy server to access the Internet,
proceed to the next step. If your network uses a proxy server to access the Internet, follow these
instructions before proceeding to the next step:
i. Select the Proxy Settings tab.
ii. Select the Check this box if your network uses a proxy server to access the Internet check
box.
iii. In the Proxy Server field, enter the proxy server address and port number, and then click the
Apply button.
d. Select the HP Web Services tab and click the Enable button. The product configures the connection
to the Internet, and then a message appears informing you that an information sheet will be
printed.
e. Click the OK button. An information page prints out. On the information page, look for the e-mail
address that is automatically assigned to the product.
3. To print a document, attach it to an e-mail message, and then send the message to the product's e-mail
address. Go to
www.hpeprintcenter.com for a list of supported document types
4. Optionally, use the HP ePrintCenter Web site to define security settings and to configure default print
settings for all HP ePrint jobs sent to this product:
a. Open a Web browser and go to
www.hpeprintcenter.com.
b. Click Sign In, and enter your HP ePrintCenter credentials or sign up for a new account.
c. Select your product from the list, or click the + Add printer button to add it. To add the product,
you need the product code, which is the segment of the product e-mail address that is before the
@ symbol.
NOTE: This code is valid for only 24 hours from the time you enable HP Web Services. If it
expires, follow the instructions to enable HP Web Services again, and obtain a new code.
d. Click the Setup button. The HP ePrint Settings dialog box appears. Three tabs are available:
72 Chapter 7 Print tasks ENWW