Material Safety Data Sheet

Skin contact Wash affected areas thoroughly with mild soap and water. Get medical attention if irritation
develops or persists.
Eye contact Do not rub eyes. Immediately flush with large amounts of clean, warm water (low pressure) for at
least 15 minutes or until particles are removed. If irritation persists, consult a physician.
Ingestion Rinse mouth out with water. Drink one to two glasses of water. If symptoms occur, consult a
physician.
Most important
symptoms/effects, acute and
delayed
Not available.
5. Fire-fighting measures
Suitable extinguishing media CO2, water, or dry chemical
Unsuitable extinguishing
media
None known.
Specific hazards arising from
the chemical
Not applicable.
Special protective equipment
and precautions for
firefighters
Not available.
Fire-fighting
equipment/instructions
If fire occurs in the printer, treat as an electrical fire.
Specific methods None established.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Minimize dust generation and accumulation.
Methods and materials for
containment and cleaning up
Not available.
Environmental precautions Do not flush into surface water or sanitary sewer system. See also section 13 Disposal
considerations.
7. Handling and storage
Precautions for safe handling Keep out of the reach of children. Avoid inhalation of dust and contact with skin and eyes. Use with
adequate ventilation. Keep away from excessive heat, sparks, and open flames.
Conditions for safe storage,
including any
incompatibilities
Keep out of the reach of children. Keep tightly closed and dry. Store at room temperature. Store
away from strong oxidizers.
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Value
Components
Form
Type
PEL 15 mg/m3
Total dust.
Titanium dioxide (CAS
13463-67-7)
US. ACGIH Threshold Limit Values
Value
Components Type
TWA
10 mg/m3
Titanium dioxide (CAS
13463-67-7)
US. NIOSH: Pocket Guide to Chemical Hazards
Value
Components Type
TWA
6 mg/m3Amorphous silica (CAS
7631-86-9)
Biological limit values No biological exposure limits noted for the ingredient(s).
2 / 6
Material name: CF213A
12827 Version #: 04 Revision date: 12-Oct-2015 Issue date: 16-Apr-2015
SDS US