Manual

Configure IP network settings
Printer sharing disclaimer
HP does not support peer-to-peer networking, as the feature is a function of Microsoft operating systems
and not of the HP print drivers. Go to Microsoft at
www.microsoft.com.
View or change network settings
Use the HP Embedded Web Server to view or change IP configuration settings.
1. Print a configuration page, and locate the IP address.
●
If you are using IPv4, the IP address contains only digits. It has this format:
xxx.xxx.xxx.xxx
●
If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It
has a format similar to this:
xxxx::xxxx:xxxx:xxxx:xxxx
2. To open the HP Embedded Web Server, type the IP address into the address line of a Web
browser.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and
default gateway.
1.
On the product control panel, press the Home
button.
2. Open the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPV4 Settings
●
Config Method
3. Highlight the Manual option, and then press the OK button.
4. Highlight the Manual Settings menu, and then press the OK button.
5. Select the IP Address, Subnet Mask, or Default Gateway option.
110 Chapter 6 Manage the product ENWW