HP LaserJet Enterprise Flow MFP M830 - Warranty and Legal Guide
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
1. The product was tested in a typical conguration with HP Personal Computer Systems.
2. For regulatory purposes, this product is assigned a Regulatory model number. This number should not be confused with the product name or the
product number(s).
3. The product meets the requirements of EN55022 & CNS13438 Class A in which case the following applies: “Warning — This is a class A product. In
a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.”
4. Telecom approvals and standards appropriate for the target countries/regions have been applied to this product, in addition to those listed above.
5. This product uses an analog fax accessory module which Regulatory Model number is: BOISB-0703-00 as needed to meet technical regulatory
requirements for the countries/regions this product will be sold.
Boise, Idaho USA
1 November 2015
For Regulatory Topics only, contact:
European Contact: HP Deutschland GmbH, HQ-TRE, 71025 Böblingen, Germany
www.hp.eu/certicates
USA Contact: HP Inc., 1501 Page Mill Road, Palo Alto, CA 94304 650-857-1501
ENWW Declaration of conformity 37