HP Color LaserJet Pro MFP M477 - Warranty and Regulatory Guide

compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party
Line Service is subject to state taris.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to le a complaint with the
FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could
aect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please see the numbers in this manual for repair and (or) warranty
information. If the trouble is causing harm to the telephone network, the telephone company may request you
remove the equipment from the network until the problem is resolved.
The customer can do the following repairs: Replace any original equipment that came with the device. This
includes the toner cartridge, the supports for trays and bins, the power cord, and the telephone cord. It is
recommended that the customer install an AC surge arrestor in the AC outlet to which this device is connected.
This is to avoid damage to the equipment caused by local lightning strikes and other electrical surges.
Telephone Consumer Protection Act (US)
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other
electronic device, including fax machines, to send any message unless such message clearly contains, in a
margin at the top or bottom of each transmitted page or on the rst page of the transmission, the date and time
it is sent and an identication of the business, other entity, or individual sending the message and the telephone
number of the sending machine or such business, or other entity, or individual. (The telephone number provided
cannot be a 900 number or any other number for which charges exceed local or long distance transmission
charges).
Industry Canada CS-03 requirements
Notice: The Industry Canada label identies certied equipment. This certication means the equipment meets
certain telecommunications network protective, operational, and safety requirements as prescribed in the
appropriate Terminal Equipment Technical Requirement document(s). The Department does not guarantee the
equipment will operate to the user’s satisfaction. Before installing this equipment, users should ensure that it is
permissible for the equipment to be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. The customer should be aware that
compliance with the above conditions may not prevent degradation of service in some situations. Repairs to
certied equipment should be coordinated by a representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment. Users should ensure for their own protection
that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe
system, if present, are connected together. This precaution can be particularly important in rural areas.
ATTENTION : Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalence Number (REN) of
this device is shown on the regulatory chassis label.
This product meets the applicable Industry Canada technical specications. / Le présent matériel est conforme
aux specications techniques applicables d’Industrie Canada.
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer
44 Chapitre 3 Informations réglementaires FRWW