HP Designjet 510 Printer Series - Assembly Instructions: Korean

ZHCN

ZHTW

8 9 Replace Set-Up Printheads with Active Printheads / /

/ /

9:1

When you are prompted to do so in the front panel, open

the window and locate the carriage assembly. This will be

accessible once the ink tubes and set-up printheads have

lled with ink.

8:3

Close the ink cartridge cover. The printer starts to initialize

its ink system as soon as the last cartridge is inserted.

Wait for about a minute until this has nished.

The set-up printheads are provided to protect the ink system while the printer is being transported from the factory, and to ll

up the ink tubes inside the printer when it is rst initialized. They must be replaced by active (normal) printheads when the

printer’s tubes have lled with ink. Set-up printheads cannot be used for printing. It is important not to remove the set-up print-

heads too early, as they are required while the printer is being initialized. When you have removed the set-up printheads (as

described in this stage), you should throw them away, as they cannot be used for printing and are not needed any more.

ap.indd 11 9/30/2010 4:09:07 PM