HP Designjet 510 Printer Series - Assembly Instructions: Korean

EN
KO
ZHCN
ZHTW
JP
10:6
With the blue-colored roll stop on the right (as seen from
the back of the printer), slide the spindle into the printer left
and then right as shown by the arrows. The paper should
oriented on the roll exactly as shown.
10
10:5
Put the removable stop on to the upper end of the
spindle, and push it down as far as it will go.
10:3
The spindle has a stop at each end to keep the roll in
position. The stop that is colored blue can be removed to
mount a new roll; it slides along the spindle to hold rolls
of different widths. Remove the blue-colored stop from the
spindle end, and stand the spindle vertically, with the xed
stop on the oor.
10:4
Slide the new roll of paper on to the spindle. Make sure the
orientation of the paper is loaded exactly as shown. If it is
not, remove the roll, turn it through 180 degrees vertically
and slide it back on to the spindle.
ap.indd 15 9/30/2010 4:09:10 PM