HP Designjet 510 Printer Series - Assembly Instructions: Korean

ZHCN

ZHTW

12:5

When you have inserted the card, screw it into place, using

its two screws (at the top and bottom of the card). Again,

this can be done with a screwdriver or manually.

12:4

To insert a LAN card (or an Accessory card), remove the

metal cover from the appropriate slot by unscrewing its two

screws. You can use a screwdriver or do it manually.

12:2

Carefully remove the plastic cover from the left-hand back

of the printer by unclipping it. This cover gives access to the

two slots for an Accessory card and a LAN card.

a. Press in the thumb-tab on the side furthest from the edge

that has the cable-hole.

b. Ease the cover out in the direction of the embossed

arrow, pivoting it by the hinge clips on the side that has the

edge cable-hole.

12:3

Remove the cover completely. Inside the compartment there

are two slots for a LAN card or an Accessory card. You can

use either slot for either card, but we recommend putting a

LAN card on the left (nearer to the front of the printer) and

an Accessory card on the right. In this way the cable from

the LAN card can easily pass through the slot in the door.

ap.indd 20 9/30/2010 4:09:15 PM