HP Designjet 510 Printer Series - Assembly Instructions: Korean

ZHCN

ZHTW

You have now nished the hardware assembly and set-up

of your printer. Now you are ready to start the software

set-up. Move on to stage 13.

12:8

Network Printer: To obtain the information you’ll need when

you install the software:

• Go to the Set-up menu in the printer’s front panel.

• Select I/O Set-up and press Enter.

• Select Card ID and press Enter.

There you will nd the hardware address of your printer, as

MAC=xxxxxxxx.

You may also require an IP address or an AppleTalk name,

for which the software will prompt you.

12:6

Insert the LAN cable into the LAN card–it is simply pushed

into place with a click.

12:7

Carefully replace the plastic cover by clipping it back into

place:

a. Put the two hinge clips on the side that has the edge

cable-hole into their slots.

b. Swivel the cover in the direction opposite to the embos-

sed arrow and clip the other two tabs on the opposite side

into their slots. Ensure that the LAN cable passes correctly

through the edge cable-hole (shown by the yellow arrow)

and avoids touching the roll of paper on the spindle.

ap.indd 21 9/30/2010 4:09:16 PM