HP Designjet 510 Printer Series - Assembly Instructions: Korean

ZHCN

ZHTW

4:5

Tilt and lift the printer (1): WARNING: 2–3 people for the

E+/A0+-size model; 2 people for the D/A1-size model.

CAUTION: Ensure the area in front of the printer is clear of

any obstacles such as packaging or rolls of paper.

4:6

Tilt and lift the printer (2): Tilt the printer through 90-degrees

onto its side, and then stand it up on its legs. The printer

may seem a little wobbly on one side, but that is correct

provided the screws have been tightened as indicated in

previous steps.

4:3

Secure the stand with the four screws that have large at

heads. Two screws (on one leg) are secured normally.

CAUTION: Two of the screws on the same leg will appear

to be not fully tightened, as they will not go in as far as the

others—they should be rm but not over tight.

4:4

Ensure all four brakes are applied, as shown.

ap.indd 6 9/30/2010 4:09:03 PM