HP Designjet 510 Printer series - Introductory Information: Korean

Introductory Information
Message Explanation and action
Open window and check
printhead cover is properly
closed
Open the window and check the printhead cover.
Note: This message may also appear following a paper jam, as the printer
cannot detect the exact reason for the problem. In this case you may have to
power off the printer and even remove the power cable from the machine, in
order to recover from the problem.
Out of memory.
Data was lost
The le is too large to be processed by the printer.
Simplify the print and try re-sending the job. Try setting the Print Quality (in
the Set-up menu) to Fast or Normal instead of Best. If the problem persists, you
may have to add more memory to the formatter card that is installed in the
back of the printer.
Out of paper The printer ran out of paper while printing the calibration pattern.
Load a sheet or roll that is at least 65 cm (25 inches) long and 50 cm (20
inches) wide.
Paper advance calibration is
recommended.
Press ENTER to calibrate
You are recommended to perform the Advance calibration routine, to ensure
the optimum print quality.
Press the Enter key to create the calibration pattern.
Paper loaded with too much
skew
Press ENTER to retry
Press CANCEL to abort
During the loading of paper, the printer has detected that the paper is skewed
too much, that is, it has not been loaded straight enough. (‘Skew’ is the angle
between the actual paper edge and the correct line.)
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
Printhead warning
Poor print quality
A problem has occurred with one or more printheads. The printheads are
still functional. The problem was detected either during printhead alignment
or during troubleshooting. If you have completed the routine, the system was
unable to clean the printheads fully.
You should use the Troubleshooting routine to correct any image quality
problems that may be apparent; alternatively, you should replace the
printheads.
Roll edge not found
Please check roll edges are
non-clear
Press ENTER to retry
Press CANCEL to abort
During the loading of a roll, the printer cannot detect the side edge of the
paper. A possible cause is that the paper is transparent (clear); only opaque
paper types are supported.
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
Sheet not loaded
Load sheet with printed pattern
The printer is trying to perform a scan of the calibration pattern, but no sheet
was found.
Load the sheet that was printed by the Create pattern part of the calibration
routine.
Warning! Machine calibrations
need to be performed. Refer to
guide for instructions.
The color calibrations for the paper that is loaded have been lost.
Repeat color and advance calibrations.
Warning: printheads not
aligned
The printer has detected that the printheads have not been aligned since the
last replacement.
You should align the printheads by selecting Align printheads from the Ink
menu.
3
Hewlett-Packard Company - Learning Products - Barcelona