HP Designjet L25500 Printer Series - Add New Substrate and Image Quality Troubleshooting procedures

HP Designjet L25500 printer series Add New Substrate and Image Quality Troubleshooting
Hewlett-Packard 11
Setting Explanation If too low If too high
Cutter
enabled
If enabled, the internal
cutter cuts the substrate
transversally after every
print.
Disable the cutter in the following cases:
• You want to increase printing speed.
• You want to use the take-up reel.
• You want to cut the substrate manually or with an
external device.
• The leading edge of the substrate tends to curl and
causes substrate jams.
Substrate
advance
compensation
Your printer was
calibrated at the factory
to ensure that it
advances the substrate
accurately when using
supported substrate
types in normal
environmental
conditions. However,
you may find it useful to
recalibrate substrate
advance in certain
circumstances:
- Unsupported
substrates: different
manufacturers provide
substrates with a wide
range of properties such
as thickness or stiffness,
which may benefit from
calibration.
- Unusual but stable
environmental
conditions: if you are
printing in unusual
conditions of
temperature or humidity
and those conditions
are expected to remain
stable, recalibration
may be beneficial.
• Dark lines appear
when you use 4- or
6-pass print
modes.
• Graininess
appears when you
print at eight or
more passes.
• White lines appear when you
use 4- or 6-pass print modes.
• Graininess appears when you
print at eight or more passes.