Manualshelf

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Command Reference Guide

ManualsBrandsHP ManualsComputer AccessoriesCisco BLp-Class Ethernet Switch
41424344454647484950
2-22
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Command Reference Guide
380265-003
Chapter 2 CGESM Switch Cisco IOS Commands
boot enable-break
boot enable-break
Use the boot enable-break global configuration command to enable interrupting the automatic bootup
process. Use the no form of this command to return to the default setting.
boot enable-break
no boot enable-break
Syntax Description This command has no arguments or keywords.
Defaults Disabled. The automatic bootup process cannot be interrupted by pressing the Break key on the console.
Command Modes Global configuration
Command History
Usage Guidelines When you enter this command, you can interrupt the automatic bootup process by pressing the Break
key on the console after the flash file system is initialized.
Note Despite the setting of this command, you can interrupt the automatic bootup process at any time by
pressing the MODE button on the switch front panel.
This command changes the setting of the ENABLE_BREAK environment variable. For more
information, see Appendix A, “CGESM Switch Bootloader Commands.”
Related Commands
Release Modification
12.2(25)SE1 This command was introduced.
Command Description
show boot Displays the settings of the bootup environment variables.