Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Command Reference Guide

2-549

Cisco Gigabit Ethernet Switch Module for the HP p-Class Blade System Command Reference Guide

380265-003

Chapter 2 CGESM Switch Cisco IOS Commands

system env temperature threshold yellow

Use the system env temperature threshold yellow global configuration command to configure the

difference between the yellow and red temperature thresholds which determines the value of yellow

threshold. Use the no form of this command to return to the default value.

system env temperature threshold yellow value

no system env temperature threshold yellow value

Syntax Description

Defaults These are the default values:

• Green: < 68

• Yellow: 68

• Red: 75

Command Modes Global configuration

Command History

Usage Guidelines You cannot configure the green and red thresholds but can configure the yellow threshold. Use the

system env temperature threshold yellow value global configuration command to specify the

difference between the yellow and red thresholds and to configure the yellow threshold. For example, if

the red threshold is 66 degrees C and you want to configure the yellow threshold as 51 degrees C, set the

difference between the thresholds as 15 by using the system env temperature threshold yellow 15

command.

Note The internal temperature sensor in the switch measures the internal system temperature and might vary

±5 degrees C.

Examples This example sets 15 as the difference between the yellow and red thresholds:

Switch(config)# system env temperature threshold yellow 15

Switch(config)#

value Specify the difference between the yellow and red threshold values (in Celsius). The

range is 10 to 25. The default value is 10.

Release Modification

12.2(25)SE1 This command was introduced.