Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Switch Installation
2-2 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide
Verifying Package Contents
NOTE: Carefully remove the contents from the shipping container, and check each item for damage. If
any item is missing or damaged, contact your Cisco representative or reseller for support. Return all
packing material to the shipping container, and save it.
Kit contents are as follows:
Switch Kit with Copper SFP Modules
• One CGESM
• Two small form-factor pluggable (SFP) modules
• Serial Console Cable (RJ45 to DB-9)
• Quick Setup Instructions
• Limited Warranty and Material Limitations Documentation
Switch Kit without SFP Modules
NOTE: Fiber and copper SFPs are available separately.
• One CGESM
• Serial Console Cable (RJ45 to DB-9)
• Quick Setup Instructions
• Limited Warranty and Material Limitations Documentation
HP BladeSystem p-Class SAN Connectivity Kit
The HP BladeSystem p-Class SAN Connectivity Kit is an option for the Cisco Gigabit
Ethernet Switch Module for HP BladeSystem p-Class, providing ProLiant BL servers with
support for Fibre Channel signal pass-through connectivity. The kit may be ordered
separately and installed during a new deployment or later as an upgrade.
If you are installing the kit, refer to the HP BladeSystem p-Class SAN Connectivity Kit Quick
Setup Instructions (included with the HP BladeSystem p-Class SAN Connectivity Kit) for
more information (see
http://www.hp.com/support).