Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Switch Installation
3. Insert the SFP module and close the SFP latch.
The orientation of an SFP module within a switch varies according to the SFP module
port. Be sure that the SFP module is in the right position before inserting. Refer to the
diagrams below.
Figure 2-2: Installing an SFP Module into the Left SFP Module Slots
Figure 2-3: Installing an SFP Module into the Right SFP Module
Slots
CAUTION: Do not remove the dust plugs from the fiber-optic SFP module port or the rubber
caps from the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the SFP module ports and cables from contamination and ambient light.
2-6 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide