Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Switch Installation
• Port parameters
— Ports 17 and 18 are administratively down.
— Operating mode is Layer 2 (switchport).
— Interface speed and duplex mode is autonegotiate.
— Auto-MDIX is enabled.
— Flow control is off.
— Power over Ethernet (PoE) is autonegotiate.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
No Smartports macros are defined.
VLANs
— Default VLAN is VLAN 1.
— VLAN trunking setting is dynamic auto (DTP).
— Trunk encapsulation is negotiate.
— VTP mode is server.
— VTP version is Version 1.
— Voice VLAN is disabled.
For STP, PVST+ is enabled on VLAN 1. Port Fast is enabled on ports 1 to 16.
MSTP is disabled.
Optional spanning-tree features are disabled.
Flex Links are not configured.
DHCP snooping is disabled. The DHCP snooping information option is enabled.
IP source guard is disabled.
IGMP snooping is enabled. No IGMP filters are applied.
IGMP throttling setting is deny.
MVR is disabled.
Port-based traffic
— Broadcast, multicast, and unicast storm control is disabled.
— No protected ports are defined.
— Unicast and multicast traffic flooding is not blocked.
— No secure ports are configured.
CDP is enabled.
UDLD is disabled.
SPAN and RSPAN are disabled.
RMON is disabled.
2-8 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide