Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Upgrading from a Previous Switch
3-2 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide
To upgrade from an existing GbE2 Interconnect Switch, a GbE Interconnect Switch, an RJ-45
Patch Panel 2, or an RJ-45 Patch Panel to a Cisco Gigabit Ethernet Switch Module:
NOTE: Illustrations are used for an example and may look different than your specific product.
1. Disconnect the cables from the modules on the rear side of the switch.
2. Remove the modules.
NOTE: SAN modules are supported by the CGESM. Therefore, if they are already installed you do not
need to remove them.
Figure 3-1: Removing the Modules
3. Remove the switch or patch panel.
Figure 3-2: Removing an Existing Switch or Patch Panel
4. To install the new switch, refer to the instructions in the “Installing a Switch” section in
Chapter 2.
5. Repeat steps 1 through 4 for the other switch in the pair.