Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Troubleshooting
4. Remove the switch from the enclosure.
Figure 4-2: Removing the Switch
5. To install the new switch, refer to the instructions in the “Installing a Switch” section in
Chapter 2.
If you saved the configuration file to a TFTP server, download the configuration. For more
information on downloading a configuration file, refer to the Cisco Gigabit Ethernet Switch
Module for HP BladeSystem p-Class Software Configuration Guide located on the HP
website at
http://www.hp.com/support.
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide 4-5