Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Configuring the Switch Using CLI
3. Enter an enable secret password, and press Return.
The password can be from 1 to 25 alphanumeric characters, can start with a number, is
case sensitive, allows spaces, but ignores leading spaces. The secret password is
encrypted and the enable password is in plain text.
Enter enable secret: secret_password
4. Enter an enable password, and press Return.
Enter enable password: enable_password
5. Enter a virtual terminal (Telnet) password, and press Return.
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows
spaces, but ignores leading spaces.
Enter virtual terminal password: terminal-password
6. (Optional) Configure Simple Network Management Protocol (SNMP) by responding to
the prompts. You can also configure SNMP later through the CLI or CiscoWorks
interface. To configure SNMP later, enter no.
Configure SNMP Network Management? [no]: no
7. Enter the interface name (physical interface or VLAN name) of the interface that
connects to the management network, and press Return. For this release, always use
vlan1 as that interface.
Enter interface name used to connect to the management network from the
above interface summary: vlan1
8. Configure the interface by entering the switch IP address and subnet mask and pressing
Return. The IP address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
9. Enter Y to configure the switch as the cluster command switch. Enter N to configure it as
a member switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in CiscoWorks. You can
configure the switch as a command switch later through the CLI or CiscoWorks interface.
To configure it later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch, and the switch displays
its initial configuration. This is an example of output that appears:
The following configuration command script was created:
hostname host_name
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide D-5