Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Configuring the Switch Using CLI
D-6 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide
•
•
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet2/0/28
!
end
10. These choices are displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in
NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the configuration that you created.
If you want to change this configuration or want to perform other management tasks, use one
of these tools:
Command-line interface (CLI)
CiscoWorks
To use the CLI, enter commands at the host_name> prompt through the console port by using
a terminal program or through the network by using telnet. For configuration information,
refer to the switch software configuration guide or the switch command reference guide.
Refer to the switch software configuration guide for instructions on how to use CiscoWorks.