Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

E
Configuring the Switch Using Express Setup
Overview
Express Setup is a browser-based program that you can use to set up and configure the
switch. You assign the IP information so that the switch can connect to local routers and the
Internet. The IP address is also required if you plan to further configure the switch.
For setup instructions using the command line interface (CLI)-based setup program, refer to
Appendix D, “Configuring the Switch Using CLI.”
The setup procedure is described in the following sections:
•
•
•
•
Running Express Setup
Configuring the Switch Settings
Managing the Switch
In Case of Difficulty
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide E-1