Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Configuring the Switch Using Express Setup
Verifying Switch IP Address
This procedure is optional. After you have installed the switch in your network, follow these
steps to verify the IP address configured on your switch:
1. Launch a web browser on a PC or workstation that is connected the same network to
which your newly configured switch is also connected.
2. Enter the IP address of your switch (for example:
192.168.2.30). The switch Device
Manager window appears, as shown in Figure E-7.
Figure E-7: CGESM Device Manager Window
E-8 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide