Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide

Index
I
port duplex mode 1-5
port LEDs 1-5
initial configuration of the switch 2-10
port mode LEDs 1-5
installation
port modes 1-5
cabling 2-9
port speed 1-5
hardware 2-3
port status 1-5
initial power-up 2-4
POST results 4-1
overview 2-1
power requirements B-1
planning configuration 2-7
power-up procedures, initial 2-4
troubleshooting 4-7
problems, diagnosing 4-6
installation guidelines 2-3
product overview 1-1
installing a new switch 2-4
ProLiant BL p-Class GbE Interconnect Switch,
upgrading from 3-1
installing SFP modules 2-5
interconnect modules
ProLiant BL p-Class GbE2 Interconnect Switch,
upgrading from 3-1
cabling procedure 2-9
IP address, clearing 4-2
ProLiant BL p-Class RJ-45 Patch Panel 2, upgrading
from 3-1
J
ProLiant BL p-Class RJ-45 Patch Panel, upgrading
from 3-1
Japanese regulatory notice A-2
R
K
rear panel
kit contents
description 1-8
Switch Kit with Copper SFP Modules 2-2
SFP module ports 1-8
Switch Kit without SFP Modules 2-2
regulatory compliance notices A-1
Korean regulatory notice A-2
remote access from a workstation via Ethernet to the
switch
L
with DHCP service available 2-11
without DHCP service available 2-12
laser device regulatory compliance notice A-3
removing SFP modules from SFP module slots 4-3
local access from a workstation connected to the
switch console port
replacing an existing switch 4-4
replacing an existing switch or patch panel 3-1
with DHCP service available 2-10
running POST 2-13
without DHCP service available 2-11
location of MAC address label 1-9
S
M
SFP module ports, description 1-8
SFP modules 1-8
MAC address
SFP modules, removing 4-3
description 1-9
SNMP network management 1-10
location of 1-9
Spd LED 1-5
management options 1-10
specifications of the switch B-1
Stat LED 1-5
N
switch connectivity 1-1
Switch Kit with Copper SFP Modules 2-2
network configurations 1-10
Switch Kit without SFP Modules 2-2
switch specifications B-1
O
System (Syst) LED
overview of product 1-1
colors 1-5
description 1-5
P
status of 1-5
package contents, verifying 2-2
physical dimensions B-1
planning the switch configuration 2-7
Index-2 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Hardware Installation Guide