Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SE1

• CSCee37070

An 802.1x port in single-host mode with port security enabled goes into the errdisable

state and displays the %DOT1X-5-SECURITY_VIOLATION message if another MAC

is seen.

The workaround is to have only one device connected at a time when the port is in single-

host mode.

•

CSCee93822

When port security is enabled on an interface in restricted mode and the switchport

block unicast interface command has been entered on that interface, MAC addresses are

incorrectly forwarded when they should be blocked

The workaround is to enter the no switchport block unicast interface configuration

command on that specific interface.

CSCef65587

These error messages appear randomly:

%SYS-2-NOBLOCK: idle with blocking disabled. -Process= “hpm main process”, ipl= 0,

pid= 62

-Traceback= 259CC0 251438 750244 661220 665774 6603CC 653750 6575B0 64FC44 651260

65DF58 4EC268 544300 4F5F64 4B433C 522508

*Sep 2 15:42:22: %SYS-2-BLOCKHUNG: Task hung with blocking disabled, value = 0x1.

-Process= "hpm main process", ipl= 0, pid= 62

-Traceback= 259CFC 251438 750244 661220 665774 6603CC 653750 6575B0 64FC44 651260

65DF58 4EC268 544300 4F5F64 4B433C 522508

This does not affect switch functionality. There is no workaround.

CSCef68181

The show mac-address-table count displays space for 8200 MAC addresses, and it

should show 8192. It can only support 8192.

There is no workaround.

CSCef81034

The show version shows a partial image.

There is no workaround.

CSCef92631

If you reload the switch through the device manager, the syslog message says that the

reload request was through the console rather than through the device manager.

There is no workaround.

CSCef98072

An unconfigured switch will initially prompt with "Would you like to terminate

autoinstall? [yes]". If the switch has already been assigned its IP address by autoinstall

(logged as 00:02:13: AUTOINSTALL: Vlan1 is assigned 192.168.2.34), autoinstall

terminates regardless of how you answer the prompt.

See the hardware installation guide for installing and configuring the switch.

16 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SE1