Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SE1

• CSCeg45884

When configuring the switch to use DHCP to assign an IP address for the management

VLAN interface, you need to use the CLI interface. The option is not configurable

through the device manager.

There is no workaround.

•

CSCeg67844

When using SNMP, the CGESM switch returns an incorrect value of 65534 for the

ciscoFlashPartitionFileCount MIB; the switch actually contains 1367 files.

There is no workaround.

Open HP Caveats

These are the HP severity 2 open caveats for this release:

rQm 263546

Disconnecting the cable from the console port does not end a Telnet session. If you are in

privileged EXEC mode when you remove the cable, the next session that is started on the

console port will also be in privileged EXEC mode.

The workaround is to end the session before you remove the cable.

rQm 266129

If you power on a switch that does not have a config.txt file (the factory default file) and

leave the switch on for few hours, the switch console appears to be stalled during setup.

The workaround is to reload the switch before you continue to configure it.

rQm 267071

When the switch is configured to obtain an IP address through DHCP (or has no IP

address) and SNMP is enabled, these advisory messages might appear during switch

initialization. The messages can be ignored because SNMP will be successfully

initialized when the switch obtains an IP address through DHCP.

"%IP_SNMP-3-SOCKET: can't open UDP socket

Unable to open socket on port 161"

There is no workaround.``

rQm 267393

The device manager Configuration->SmartPorts web page displays the uplink ports in

an incorrect order, 19, 21, 20, 22.

See the “Cabling the Switch” section in the quick setup instructions for the correct layout

of the uplink ports.

18 Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SE1