Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SEE1 and later

459516-002

Resolved Caveats

• CSCsd51530

When you telnet to a switch and enter the autocommand-options nohangup interface configuration

command on VTY lines 0 through 4, you can now successfully log out and telnet back into the

switch.

In previous releases, when you logged out of the switch and then tried to open a new Telnet session,

the switch would automatically log you out.

• CSCse48664

The dot1dBasePort values in the Bridge-MIB now match the front-panel numbering for the switch

FastEthernet interfaces.

• CSCse49694

These error messages no longer appear on a CGESM switch running Cisco IOS

Release

12.2(25)SEE2 or later:

00:01:32: %PLATFORM_ENV-1-PWR: Faulty redundant power supply detected

00:01:31:%PLATFORM_ENV-1-PWR: Faulty internal power supply detected

In previous releases, the messages appeared when the image was first loaded onto the switch and

continued to appear every five minutes.

• CSCse55723

A Telnet session no longer stops if you press the Space or Enter key when the show command output

is scrolling.

Resolved IOS Caveats in Cisco IOS Release 12.2(25)SEE1

These are the resolved IOS caveats in Cisco IOS Release 12.2(25)SEE1:

• CSCea80105

When a Cisco IP Phone is connected to a switch, only the Voice VLAN (VVID) of the switch learns the

MAC address of phone. This is the correct behavior.

In previous releases, the MAC address was learned on both the VVID and the Data VLAN (PVID).

When the dynamic MAC addresses were removed (manually or automatically) either by a topology

change or by enabling or disabling the port security or IEEE 802.1x feature, the MAC address of

Cisco IP Phones MAC address was re-learned only on the VVID.

• CSCee37070

When an 802.1x-enabled port is in single-host mode and has port security enabled, the port no longer

goes into the error-disabled state and displays this system message if another MAC address is

detected on the port:

%DOT1X-SECURITY_VIOLATION

• CSCef65587

These error messages no longer randomly appear:

%SYS-2-NOBLOCK: idle with blocking disabled. -Process= "hpm main process", ipl= 0,

pid= 62

-Traceback= 259CC0 251438 750244 661220 665774 6603CC 653750 6575B0 64FC44 651260

65DF58 4EC268 544300 4F5F64 4B433C 522508

*Sep 2 15:42:22: %SYS-2-BLOCKHUNG: Task hung with blocking disabled, value = 0x1.

-Process= "hpm main process", ipl= 0, pid= 62

-Traceback= 259CFC 251438 750244 661220 665774 6603CC 653750 6575B0 64FC44 651260

65DF58 4EC268 544300 4F5F64 4B433C 522508