Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(35)SE and later

383623-007

Resolved Caveats

• rQm 266129

If you power on a switch that does not have a config.txt file (the factory default file) and leave the

switch on for few hours, the switch console appears to be stalled during setup.

The workaround is to reload the switch before you continue to configure it.

Open Device Manager Caveats

This is the severity 3 device manager caveat for this release:

• CSCef94061

If you enter the letter i by itself in the port description, the VLAN status column displays i; this only

occurs when you are using Device Manager through Netscape 7.1.

The workaround is to run Device Manager through Internet Explorer if you must enter a port

description with only the value “i.”

Resolved Caveats

These sections describe the resolved caveats for the CGESM switch:

• CSCee22376

When an SNMP version 3 user is configured with the encrypted option and password, the switch no

longer reloads when the MIB object usmUserAuthKeyChange is set.

• CSCef94061

If you entered the letter i by itself in the port description, the VLAN status column no longer

displays only i ; this only occurred when you were using Device Manager through Netscape 7.1.

• CSCeg04311

no longer appear:

%Error opening tftp://255.255.255.255/network-confg (Timed out)

%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)

%Error opening tftp://255.255.255.255/router-confg (Timed out)

%Error opening tftp://255.255.255.255/ciscortr.cfg (Timed out)

These system messages also appeared:

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/network-confg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/cisconet.cfg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/switch-confg) failed

00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from

(tftp://255.255.255.255/ciscortr.cfg) failed

• CSCeg67844

When using SNMP, the switch no longer returns an incorrect value of 65534 for the

ciscoFlashPartitionFileCount MIB.