Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(35)SE and later

383623-007

Documentation Updates

Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_VVLAN: Data VLAN [dec] on port [chars]

cannot be equivalent to the Voice VLAN.

Explanation

The IEEE 802.1x-assigned VLAN on a port cannot be the same as the voice VLAN.

[dec] is the data VLAN ID, and [chars] is the port.

Recommended Action Configure either a different voice VLAN or a different IEEE 802.1x-assigned

access VLAN on the interface. The authentication then proceeds normally on the next retry.

Error Message FRNTEND_CTRLR-1-MGR_TXQ_FULL: The front end controller Tx queue

reached watermark level

Explanation

There are too many messages in the queue between the front-end controller and the

switch software.

Recommended Action Try reloading the switch. If this does not resolve the issue, this might be a

hardware problem. Contact the Cisco technical support representative.

Error Message GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for

GBIC in port [chars]

Explanation

The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but the system could not verify its identity. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software. Otherwise, verify that the SFP module was

obtained from Cisco or from a supported vendor.

Error Message GBIC_SECURITY_CRYPT-4-UNRECOGNIZED_VENDOR: GBIC in port [chars]

manufactured by an unrecognized vendor

Explanation

The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but the switch could not match its manufacturer with one on the known list of Cisco SFP module

vendors. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software.

Error Message GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port [chars] has bad

crc

Explanation

The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but it does not have a valid cyclic redundancy check (CRC) in the EEPROM data. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software. Even if the switch does not recognize the SFP

module, it might still operate properly but have limited functionality.