Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(40)SE

21
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(40)SE
460160-001
Documentation Updates
The CONFIG_FILE environment variable can also be reset by using the no boot config-file
global configuration command.
The HELPER_CONFIG_FILE environment variable can also be reset by using the no boot
helper-config-file global configuration command.
System Messages Guide
These are the documentation updates for the system modesties guide:
• New System Messages, page 21
• Changed System Messages, page 22
New System Messages
The following system messages have been added.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, manually remove it from that port.
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Explanation The interface has been added to all VLANs. [chars] is the added interface.
Recommended Action No action is required.
Error Message SPANTREE-6-PORTDEL_ALL_VLANS: [chars] deleted from all Vlans
Explanation The interface has been deleted from all VLANs. [chars] is the deleted interface.
Recommended Action No action is required.
Error Message SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to [chars].
Explanation
The VLAN Trunking Protocol (VTP) domain name was changed through the
configuration to the name specified in the message. [chars] is the changed domain name.
Recommended Action No action is required.