Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes Cisco IOS Release 12.2(44)SE1 and later

16
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-005
Resolved Caveats
Open Device Manager Caveats
This is the severity 3 device manager caveat for this release:
• CSCef94061
If you enter the letter i by itself in the port description, the VLAN status column displays i; this only
occurs when you are using Device Manager through Netscape 7.1.
The workaround is to run Device Manager through Internet Explorer if you must enter a port
description with only the value
“i.”
Resolved Caveats
This section describes the caveats that have been resolved in these releases:
• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5” section on page 16
• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE3” section on page 17
• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE2” section on page 17
• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE1” section on page 18
• “Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE” section on page 21
Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5
• CSCsd73245
Excessive IPRT-3-PATHIDX error messages no longer appear in the log file.
• CSCsf10850
When configuring an IP SSH version 2 connection, you can no longer create an RSA key that is less
than
768 bits.
• CSCso63475
A switch now boots correctly after a software reload or power cycle. In previous releases, under
some rare circumstances, the image would be truncated to zero bytes and the switch would not boot.
• CSCsu10229
The cdpCacheAddress value now appears in a GLOBAL_UNICAST address.
• CSCsu40077
The switch now correctly processes ingress traffic when a port is configured with a short 802.1x
tx-period timer value (such as dot1x timeout tx-period 3).
• CSCsu47056
The username is now properly logged when the remote command privileged EXEC command is
used to configure a cluster member.