Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes Cisco IOS Release 12.2(44)SE1 and later

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later

464831-005

Resolved Caveats

• CSCsm08603

This traceback error no longer appears when you enter the show aaa subscriber profile privileged

EXEC command:

*Mar 2 01:50:41.127: %PARSER-3-BADSUBCMD: Unrecognized subcommand 10 in exec command

'show aaa subscriber profile WORD'

-Traceback= D003B4 D00AC8 C908A0 C2F040 C8CA18 CB8984 93B670 932338

Note In Cisco IOS Release 12.2(44)SE2 and later, the subscriber keyword is no longer supported.

(The show aaa subscriber profile command is not supported, and you cannot configure the aaa

subscriber profile command.)

• CSCsm26406

Enhanced IGRP (EIGRP) now works correctly when you enter the ip authentication key-chain

eigrp interface configuration command.

• CSCsm61718

A switch no longer unexpectedly reloads when you configure two or more authentication,

authorization, and accounting (AAA) broadcast groups.

• CSCso75848

The switch no longer experiences a memory leak during an HTTP core process.

Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE1

• CSCec51750

A router that is configured for HTTP and voice-based services no longer unexpectedly reloads due

to memory corruption.

• CSCek57932

Cisco uBR10012 series devices automatically enable Simple Network Management Protocol

(SNMP) read/write access to the device if configured for linecard redundancy. This can be exploited

by an attacker to gain complete control of the device. Only Cisco uBR10012 series devices that are

configured for linecard redundancy are affected.

Cisco has released free software updates that address this vulnerability. Workarounds that mitigate

this vulnerability are available.

This advisory is posted at

http://www.cisco.com/warp/public/707/cisco-sa-20080924-ubr.shtml.

• CSCsd45672

When AAA is enabled and you use the aaa group server radius group-name global configuration

command to put the switch in server group configuration mode, entering the server-private

command no longer causes the switch to reload.