Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes Cisco IOS Release 12.2(44)SE1 and later

22
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-005
Resolved Caveats
• CSCsc26726
Gigabit interfaces 0/23 and 0/24 now link up with another switch when the interface speed is set to
an explicit value. In previous releases, these ports would only link up with another switch if the ports
on that switch were set to autonegotiate.
• CSCsc30733
This error message no longer appears during authentication when a method list is used and one of
the methods in the method list is removed:
AAA-3-BADMETHODERROR:Cannot process authentication method 218959117
• CSCsd01180
The switch no longer reloads when you use a Kron command scheduler routine to automatically
copy configuration data using the Secure Copy Protocol (SCP). (Kron is a Cisco IOS utility for
scheduling non-prompting CLI commands to execute at a later time.)
• CSCsd78044
When IGMP snooping is enabled and an EtherChannel member interface fails, the switch no longer
stops forwarding multicast traffic on the EtherChannel. In previous releases, this occurred when
multicast routing was enabled and the EtherChannel interface was a member of a multicast group not
directly connected (that is, the multicast group that did not have the C flag set in the show ip mroute
privileged EXEC command output).
• CSCsd85770
This error message no longer appears when you apply the mls qos trust dscp global configuration
command to a port:
Master sets trust failed, sets to untrust modetrust type update
failed on ifc GigabitEthernetx/x
Switch(config-if)#Tcam write failed trust dscp
%QOSMGR-4-COMMAND_FAILURE: Execution of slave:HQM_IDBTRUST_CMD
command failed on GigabitEthernetx/x
• CSCse14774
When a switch is connected to a third-party router through an EtherChannel and the EtherChannel
is running in Link Aggregation Control Protocol (LACP) mode, the interfaces in the EtherChannel
no longer fail after you enter the switchport trunk native vlan vlan-id interface configuration
command to change the native VLAN from VLAN 1 (the default) to a different VLAN ID.
• CSCsg21537
When MAC addresses are learned on an EtherChannel port, the addresses are now correctly deleted
from the MAC address table.
• CSCsg30295
When you configure an IP address on a switch virtual interface (SVI) with DCHP and enable DHCP
snooping on the SVI VLAN, the switch SVI can now obtain an IP address.
• CSCsg70630
A switch with the Dynamic ARP Inspection feature enabled no longer experiences the issue that
triggered the display of buffer sharecount messages under certain patterns of ARP packet traffic.
• CSCsh74395
When a VLAN includes multiple MAC addresses, the number of MAC addresses shown in SNMP
now matches the output of the show mac-address count vlan vlan-id privileged EXEC command.