Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes Cisco IOS Release 12.2(44)SE1 and later

Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later

464831-005

Resolved Caveats

• CSCsi08513

MAC flap-notification no longer occurs when a switch is running VLAN bridge spanning-tree

protocol (STP) and fallback bridging is configured on the VLANs running STP.

• CSCsi10584

Multiple Spanning-Tree Protocol (MSTP) convergence time has been improved for Cisco IOS

Release 12.2.

• CSCsi63999

Changing the spanning tree mode from MSTP to other spanning modes no longer causes tracebacks.

• CSCsi77705

Broadcast storm control now works correctly on IEEE 802.1Q trunk ports.

• CSCsi78737

The cpmCPURising Threshold traps on the switch are no longer missing the

cpmProcExtUtil5SecRev and cpmProcessTimeCreated trap components. Note that although the

components were missing from the traps, the PROCESS MIB was still populating the objects.

• CSCsj22994

ACLs are now configured correctly when they contain ICMP codes 251 to 255.

• CSCsj47067

If you upgrade from Cisco IOS Release 12.2(35)SE1 to Release 12.2(37)SE, a security violation no

longer occurs when:

–

You enter the switchport port-security maximum 1 vlan access interface configuration

command.

–

An IP phone with a PC behind it is connected to an access port with port security.

• CSCsj52956

The TxBufferFullDropCount counter no longer increments when the switch is a standalone switch.

• CSCsj53001

The Total- output-drops field in the show interfaces privileged EXEC command output now

displays accurate ASIC drops.

• CSCsj64882

When IGMP snooping is enabled, CGMP interoperability mode now works as it should when the

upstream multicast router is set up correctly with PIM and IP CGMP.

• CSCsj77933

If you enter a space before a comma in the define interface-range or the interface range global

configuration command, the space before the comma is now saved in the switch configuration.

• CSCsj87991

A switch configured for Link Layer Discovery Protocol (LLDP) now correctly reports the enabled

switch capabilities in the LLDP type, length, and value (TLV) attributes.

• CSCsj90406

When VTP pruning is enabled, the switch no longer might experience high CPU usage (greater than

90 percent) for up to 20 minutes after the link comes up simultaneously on multiple trunk ports.